
36
18
AR2150
4.8 To replace the liners liner and baffle reverse these
procedures.
5. MAIN BURNER
5.1 To remove the main burner:
Remove the baffle and ceramic liners, see Section 4.
Remove the burner bracket screw on the left hand side of
the firebox, Diagram 19.
Remove the three securing screws from the edges of
the burner, Diagram 19.
19
AR1868
Screws
Burner Bracket
5.2 Slide the burner to the left whilst lifting the Left Hand side
clear of the bracket, Diagram 20.
20
AR1868
Slide to the left
and lift the Left
hand side
5.3 Slide the burner fully to the left and out of its location.
IMPORTANT: Take care when removing the burner not
to damage the ceramic pad with the pilot unit attached.
Refit in reverse order
6. CONTROL ASSEMBLY
DISCONNECT THE BATTERIES PRIOR TO REMOVAL OF
THE ASSEMBLY PARTS. SEE SECTION 5 USERS
INSTRUCTIONS.
6.1 It is not necessary to remove the complete control assembly
to service or replace parts of this appliance. The following
sections will detail how to individually remove and replace
each element.
7. PILOT UNIT
The pilot assembly consists of five components, which can
be individually changed, these are:
1) Pilot burner bracket
2) Pilot injector
3) Electrode
4) Thermocouple
5) Gasket.
7.1 Turn the gas supply off at the isolation device, remove the
door and place to one side, carefully remove the ceramic
fuel bed components including the liners.
7.2 Remove the two fixing screws from the pilot bracket, see
Diagram 21. Gently draw the assemble away from the
firebox to give access to the nuts and ignition lead.
NOTE: TAKE CARE NOT TO DAMAGE THE GASKET.
AR0614
21
7.4 To remove the pilot injector, undo the compression nut on
the pilot feed pipe and withdraw the injector which will be
hooked onto the olive. When replacing an injector always
make sure it is hooked onto the olive before inserting it into
the pilot burner. See Diagram 22.
SERVICING INSTRUCTIONS
REPLACING PARTS
Comentários a estes Manuais